by matt walker » Wed May 14, 2014 2:48 pm
Interesting set up with the SPDT switches for source select Snuffy. Lots of control that way, as opposed to a transfer switch for the whole system. I suppose there are a lot of times when you have excess power to burn, so why not invert to the kitchen outlets, or whatever. That's my kind of system, one where the operator is involved. I do a lot of designing systems and the biggest challenge is trying to design the operator out of the system, and I'm always aware that if I were designing for myself I would have much more manual control. Sounds like you did exactly that. I am curious, where is the over current protection on the circuits? Right after the source select? Each bus feeds one side of the switch, output to breaker, then load?